Презентация на тему "Safety and seamanship"

Содержание

• 
  Слайд 1

  Safety and seamanship

  ALPHA SHIP is an internationally ас-claimed shipping company with аfleet of 20 highly sophisticated fullcontainer ships that owes its goodcharter sales то an above averageperformance.

• 
  Слайд 2

  Content

  Introduction Seamanship and order Other incidents Conclusions

• 
  Слайд 3

  What is the ISPS Code?

  The International Ship and Port Facility Security Code (ISPS Code) is a comprehensive set of measures to enhance the security of ships and port facilities The purpose of the Code is to provide a standardised, consistent framework for evaluating risk, enabling Governments to offset changes in threat with changes in vulnerability for ships and port facilities through determination of appropriate security levels and corresponding security measures.

• 
  Слайд 4

  Before stowing wet manila mooring lines, you should:

  Wash them with salt water and stow immediately Dry them out without washing Wash them with fresh water, dry and stow Stow immediately after use so air with not cause dry rot Wash them with fresh water, dry and stow

• 
  Слайд 5
  

  When placing two lines from two different vessels on the same bollard, what procedure would you use?

  Never put two lines on the same bollard Bring the eye of the second line up through the eye of the first line and then over the bollard Put forward line on first and the after line on last Put one higher than the other so that they don't touch Bring the eye of the second line up through the eye of the first line and then over the bollard

• 
  Слайд 6
  

  What action should be taken with taut manila lines if rain is imminent?

  Take all slack out of them as they will stretch when wet Loosen or slack them as manila shrinks when it is wet Take extra turns around cleats and bollards because manila becomes slippery when wet Loosen or slack them as manila shrinks when it is wet

• 
  Слайд 7

  What type stopper would you use on wire rope?

  Nylon Wire Manila Chain Chain

• 
  Слайд 8

  On a windlass, what would a stripper be used for?

  To keep the chain from fouling the wild To take of the rust To remove the shot indicating wires To remove the mud from the anchor chain To keep the chain from fouling the wildcat